Between-flange mounting for cameras, lighting, and apparatus on standard I-beams — no cutting, drilling, welding, or bolting to the beam. Run the numbers on your application below.
Distance, mount to load C.G.6"
2"8"14"20"
Your load weight
lbs — fixture, camera, or apparatus weight
Mounting configuration
In-line with the flange — mounting components sit flush against the beam face.
Max Allowable Load At This Distance
57
lbs max @ this distance
WITHIN RATING
Your 50 lb load leaves 7 lb of headroom at 6".
8–12"
Flange Width Range
700 lb
Pull-Out Force
3 lb
Bracket Weight
105 ft·lb
Clamp Bolt Torque
No Weld vs. Welded Mount
BEAM ANKR
Welded Bracket
Install Time
15–30 min, 1 person
Hours — weld, cool, inspect
Crew
1 tech, hand tools
Certified welder + fire watch
Hot Work Permit
Not required
Required
Beam Condition
Unaltered, no finish removal
Permanently modified
Reusable
Yes — remove, relocate, reuse
No — scrapped on teardown
Typical avoided cost: $600–$1,200 per mounting point in welder labor, fire watch, and permit overhead.*Estimate based on typical U.S. structural welding and fire-watch labor rates for a single-bracket hot work job. Verify against local rates — not a quote.
